Daily Setup

  1. Switch on power supply
  2. Check that Flexible Steel Print Sheet is clean and damage free
  3. Run Daily Setup Check script (found in the testing folder on the SD card) this will run a Z axis calibration extrude and print a small test print.

This is an operation for Level 2 inductees and above only

facilities/fablab/equipment-cots/prusa_i3_mk3s/dailysetup.txt · Last modified: 2019/06/13 12:40 by Michael Byrne
CC Attribution-Share Alike 4.0 International Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International

We acknowledge Aboriginal and Torres Strait Islander peoples and their continuing connection to land and as custodians of stories for millennia. We are inspired by this tradition in our work to share and preserve Queensland's memory for future generations.

© The State of Queensland (State Library of Queensland)