Differences

This shows you the differences between two versions of the page.

--- facilities:fablab:equipment-cots:speedy300:start [2022/10/13 16:03]
Steven Curran
+++ facilities:fablab:equipment-cots:speedy300:start [2022/10/13 16:04] (current)
Steven Curran
@@ Line 259: / Line 259: @@
 </WRAP>
-STEP 7.  Push Enter  {{:facilities:fablab:equipment-cots:speedy300:enter.png?50|}} to start job.
-The Speedy 300 will etch black portions of the artwork first by default
-{{:facilities:fablab:equipment-cots:speedy300:img_1186.jpg?400|}}.  {{:facilities:fablab:equipment-cots:speedy300:img_1189.jpg?400|}}.    {{:facilities:fablab:equipment-cots:speedy300:img_1192.jpg?400|}}
-And then cut //Hairline// paths set to RGB red 255.
-{{:facilities:fablab:equipment-cots:speedy300:img_1195.jpg?600|}}
 <WRAP center round important 60%>
 Monitor your job, __do not walk away from the machine when job is running__. if you need to move away, pause the job by pressing pause {{:facilities:fablab:equipment-cots:speedy300:pause.png?50|}}.