Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
facilities:fablab:software:fusion360 [2018/08/03 10:29] Andrei Maberley [Fusion 360] |
facilities:fablab:software:fusion360 [2018/08/03 10:59] Andrei Maberley [Tips and Tricks] |
||
---|---|---|---|
Line 23: | Line 23: | ||
===== Tips and Tricks ===== | ===== Tips and Tricks ===== | ||
+ | |||
+ | |||
==== Parametric Design ==== | ==== Parametric Design ==== | ||
- | The tips to successful parameter usage, that is avoiding the dreaded "Over Constrained" | + | The tips to successful parameter usage, that is avoiding the dreaded "Over Constrained" |
==== ==== | ==== ==== | ||
- | Try to make sure that your parameters are controlling only a single dimension at a time. For example - a rectangle that has a length, width is fine. But if you add a curve with a radius that intersects | + | |
+ | Make sure that your parameters are controlling only a single dimension at a time. For example - a rectangle that has a length, width is fine. But if you add a curve with a radius that intersects | ||
+ | |||
+ | ==== === | ||