Printer Shelving

Table of Contents

Printer Shelving

This is an adaption of the milkcrate shelving design that has only one compartment and up to 5 shelves 1). This is a parametric design made in autodesk Fusion360.

20161205singlecompartmentcnc_drawing_v2.pdf

The model has top, bottom, side, shelf, and dividers. Here is what is looks like in a 10 crates by 10 crates size.

This is too big to be cut, but starting from an oversized model makes the parametric rescaling of sketches possible in Fusion360 2)

1)
this limit is forced by the extrusion of the back in fusion360 - to expand you just need to increase the number of shelves in parameters and re-extrude
2)
not sure if this is intended, but re-dimensioning sketches breaks the rectangular pattern on the extruded faces.
facilities/fablab/fittings-custom/printer-shelving.txt · Last modified: 2018/07/31 16:02 by Andrei Maberley
CC Attribution-Share Alike 4.0 International Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International

We acknowledge Aboriginal and Torres Strait Islander peoples and their continuing connection to land and as custodians of stories for millennia. We are inspired by this tradition in our work to share and preserve Queensland's memory for future generations.

© The State of Queensland (State Library of Queensland)