LFA Case Version 1.0

LFA Case Version 1.0

Case Design

Components

  • Custom Foam insert
  • 8 * 500mm power cables
  • 8 Socket powerboard
  • 8 * Lindy USB power chargers

Assembly

Grab the 500mm power leads and coil up until you have about 50mm of play at each end, then cable tie tight.

Slide the first PSU in the top slot

Flip the foam round and plug-in the first power-cable

Repeat for the remaining cables

Plug in all the cables to the powerboard

Wedge the powerboard into the bottom of the foam - make sure the powerboard lead is fed up through the hole.

Fit the foam in the case

Files

Current

Old

facilities/fablab/equipment-custom/library_for_all/case_v1.txt · Last modified: 2019/05/07 14:31 by Andrei Maberley
CC Attribution-Share Alike 4.0 International Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International

We acknowledge Aboriginal and Torres Strait Islander peoples and their continuing connection to land and as custodians of stories for millennia. We are inspired by this tradition in our work to share and preserve Queensland's memory for future generations.