Pausing a Cut / Clearing Debris

Table of Contents

If a piece is moving or get stuck in the extractor.

  • Pause the cut with the red stop button
  • Wait for the machine head to withdraw
  • Watch the controller
    • Wait for the spindle to stop
  • Watch the spindle - verify it has stopped.

Use emergency stop if necessary

Note -if the machine is turned OFF mid operation, wait 1 minute to turn ON.

facilities/fablab/equipment-cots/multicam_m-2412/pausing_a_cut_clearing_debris.txt · Last modified: 2018/07/23 14:27 by Michael Byrne
CC Attribution-Share Alike 4.0 International Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International

We acknowledge Aboriginal and Torres Strait Islander peoples and their continuing connection to land and as custodians of stories for millennia. We are inspired by this tradition in our work to share and preserve Queensland's memory for future generations.

© The State of Queensland (State Library of Queensland)