| FUNCTION | NOTES |
|---|---|
| Function 01 - Machine Properties | |
| Function 02 - Verify Job | |
| Function 03 - Machine Limits Control (Co-ordinate display) | |
| Function 05 - Execute M-Code | |
| Function 06 - Execute G-Code | |
| Function 07 - Enable/Disable Machine's Motors | |
| Function 09 - Abort Job | |
| Function 10 - Set User XY Origin“ |
| FUNCTION | NOTES |
|---|---|
| Function 11 - Choose Current Origin | |
| Function 12 - Seek Machine Origin | |
| Function 13 - Go to Current Origin | |
| Function 16 - Set Parking Position | |
| Function 20 - Set Material Thickness | |
| Function 24 - Set Tool Height of tangential knife heads | |
| Function 25 - Set Tool Height ” | |
| Function 26 - Set ATC Tool Heights | ATC not fitted |
| Function 27 - Set User Z Origin | |
| Function 28 - Set and Plane Waste Board“ | |
| Function 30 - Edit Tools | |
| Function 31 - Change Active Tool | |
| Function 34 - Unload Spindles | ATC not fitted |
| Function 35 - Set dual carriage spacing | ATC not fitted |
| FUNCTION | NOTES |
|---|---|
| Function 40 - Current Job Properties | |
| Function 41 - Feed Speed | |
| Function 42 - Spindle Control | |
| Function 43 - Job Repeat ” | |
| Function 44 - Job Array “ | |
| Function 45 - Plunge Speed | |
| Function 46 - Measured Move | |
| Function 47 - Cut Rectangle” | |
| Function 50 Vacuum Pump, Dust Collector and Mist Control | Not Fitted |
| Function 51 - Digitise 2D & 3D Jobs.“ | |
| Function 54 - Safety Interlock | |
| Function 56 - G41/G42 Compensation | |
| Function 58 - Multi XML ControlFunction | |
| Function 59 - G41/G42 Modal Preset ” | |
| Function 801 - Set Static IP Address | |
| Function 821 - Set up Tool Tip Sensor | |
| Function 822 - Setting up Tangential Knives |