| FUNCTION | NOTES |
|---|---|
| Tab 1 - Jobs Mode | |
| Tab 2 - Position & Jog Mode | |
| Tab 3 - Speed Mode | |
| Tab 4 - Spindle RPM | |
| Tab 5 - Origin Mode | |
| Tab 6 - Tooling Mode | |
| Tab 7 - Function Mode |
| FUNCTION | NOTES |
|---|---|
| Function 01 - Machine Properties | |
| Function 02 - Verify Job | |
| Function 09 - Abort Job | |
| Function 16 - Set Parking Position | |
| Function 20 - Set Material Thickness |
| Function 25 - Set Tool Height | |
| Function 27 - Set User Z Origin | |
| Function 28 - Set and Plane Waste Board | |
| Function 30 - Edit Tools | |
| Function 31 - Change Active Tool | |
| Function 40 - Current Job Properties | |
| Function 41 - Feed Speed | |
| Function 42 - Spindle Control | |
| Function 43 - Job Repeat | |
| Function 44 - Job Array | |
| Function 45 - Plunge Speed | |
| Function 46 - Measured Move | |
| Function 47 - Cut Rectangle |
| Function 24 - Set Knife Length | |
| Function 42 - Rotate Knife | |
| Function 58 - Swap from Spindle to Knife Control | |
| Function 67 - Knife Overcut/Undercut Compensation | |
| Function 822- Set up Tangential Knifes |