~~REVEAL~~
Milkcrates fit into Milkcrate Shelving.
These instructions cover using the files provided to;
The 3D model can be viewed, interacted with and downloaded from here https://a360.co/2D4gpg7. You will need to provide an email to recieve the download.
To customise the material thickness, dimensions and tolerances you can change the parameters of the original design in Fusion360..
The dimensions are based on the external of the chest. This is to ensure that the chest and draw fit inside our container.
Before playing with the parameters remember;
Open the model, then go to the parameters menu.
The parameters you will can change are favourites at the the top of the list.
The individual faces as DXFs are:
Layout for cutting - sheet dimension minimum 560mm x 320mm.
Rayjet Settings are:
Export for other formats:
As above - but without tabs.
The Fusion360 file and 3D model is viewable here https://a360.co/2CGh3iY
The individual faces as DXFs are:
Layout for cutting - sheet dimension minimum 535mm x 310mm - sheet (page) size 2200 x 1200.
The Fusion360 file and 3D model is viewable here https://a360.co/2DaWUG2.
The individual faces as DXFs are:
Layout for cutting. Two sheets each a full sheet dimension 726mm x 432mm for Rayjet.
Rayjet Settings are:
Export for other formats:
The individual faces as DXFs are:
Layout for cutting. Three sheets each a full sheet dimension 726mm x 432mm for Rayjet.
Created by Andrei Maberley on 2018/01/08 14:09.
contributors