~~REVEAL theme=laser_cutter_preflight&transition=fade&controls=0&show_progress_bar=1&build_all_lists=0&open_in_new_window=0~~

 ====== Laser Cutter Checks =====

The Edge standard checks for the Rayjet 300.


 ===== Laser Cutter Preflight Checks - Prepare Your Job =====

  * Hot Work Permit active
  * Material purchased, checked by supervisor
  * Honeycomb correctly seated on bed
  * Focal distance correctly calibrated to stock
  * Starting position of laser is correct 





 ===== Laser Cutter Preflight Checks - Supervisor Check =====

  * Starting position of laser is correct - verified by Supervisor
  * Bed is correctly seated - verified by Supervisor
  * Focus alignment - verified by Supervisor
  * All cut settings - verified by Supervisor 
     * power 
     * speed 
     * number of passes
  * Auto focus feature disabled - verified by Supervisor
  * Update Settings, apply and press OK




===== Laser Cutter Checks - During Cut =====

  * Start job from Laser Cutter NOT software
  * Avoid looking directly at the laser flash
      * Prolonged exposure to laser flash may cause eye strain     
  * Abort job if material catches fire
    * ALERT SUPERVISOR
  * Pause Job to adjust
    * ALERT SUPERVISOR
    * repeat pre-flight check if needed
 





===== Laser Cutter Checks - After Cut =====

  * Wait 30 secs for fumes to clear
  * Remove Job
  * Brush out or vacuum debris

===== Laser Cutter Checks - After Session ======

  *  Leave area clean and tidy
  *  Take your USB
  * Show of your work on [[http://edgeqld.org.au/madetoday-gallery/|made today]]