~~REVEAL~~
=====Changing tooling and loading material=====

----

====Changing tooling====
  * Remove dust shoe.\\ {{ :hte:projects:xcarve:dscf1411.jpg?300 |}}
=== ===
  * Locate appropriate spanner for collet\\ {{ :hte:projects:xcarve:rect6050.png?300 |}}
=== ===
  * While pressing down yellow 'Spindle Lock' button, loosen collet to remove previous tooling. \\ {{ :hte:projects:xcarve:rect6767.png?300 |}} {{:hte:projects:xcarve:dscf1413.jpg?300|}}\\ <WRAP center round alert 80%>Tooling can be surprisingly sharp and very easy to catch fingers on.\\ **Be careful!**\\ If your not comfortable doing this, please ask a supervisor.</WRAP>  
=== ===
  * Insert and tighten up new tooling, changing collet if required.
  * Reinstall dust shoe, being careful of sharp tool.
  * Press 'Reset' then 'Home' to realign machine to zero. {{:hte:projects:xcarve:resetbutton.jpg?50|}} {{:hte:projects:xcarve:candle_home.png|}}

----

====Zeroing Z(tool) height====
 ===Automatic (Preferred)===
    - Place Z-Probe brass pad under tool, clipping lead to tooling and plugging in(Next to router, right side) \\ {{:hte:projects:xcarve:dscf1347.jpg?300|}}  {{:hte:projects:xcarve:rect7373.png?250|}}
    - Press 'Z-Probe' button wait for cycle to complete. {{:hte:projects:xcarve:candle_zprobe.png|}}
    - Unplug, unclip and put away Z-Probe hardware.


 ===Manual (Expert Only)===
<hidden>
    - Lower until tool touches bed or work. Use a piece of paper to check.
    - Press 'Zero Z' button. {{:hte:projects:xcarve:candle_zzero.png|}}
    - Raise Z at least 10mm to clear bed/work
</hidden>
\\

<WRAP center round info 80%>
When your done, Press {{:hte:projects:xcarve:candle_safe.png|}}('Safe Position')\\ button to move machine out of the way. 
</WRAP>

----


====Loading Material====
  - Align material with front left 'home' position.
  - Think about how material will move, what your cut path is and where it will go.\\ <WRAP center round tip 80%>Large sheets tend to flex and lift as they are cut. Soft materials will move.\\ Placing screws as close as is safely possible the job is preferable to just putting a few around the edges of the sheet.</WRAP>
  - Secure to the bed using wood screws and cordless drill \\ <WRAP center round tip 80%>
Pre-drilling holes before screwing allows the screws to pull the material down against the waste board for better holding
</WRAP>
\\
{{:hte:projects:xcarve:dscf1420.jpg?200|}}  {{:hte:projects:xcarve:dscf1421.jpg?200|}}